In general, this should be a simple task,
You can access this using: Designer Studio > System > Settings >
Search, as shown below:
Figure 34: Accessing Pega Search Index
As you would again realise, the steps provided
in the CLSA document is not updated. ☹
Anyway, after clicking the menu item, you
would see the following:
Figure 35: Pega Search Index Screen
There is really no magic here, basically,
just scroll down and take note of the following:
Figure 36: Search Index Agent Information and Search Index Host Node Setting
For the “Agent information” section, take
note that the Queue size MUST be zero, if it is not, then very likely, you are
having some agent issue. Ask the Pega Community for help or contact CLSA Team. The
other important section is “Search index host node setting”. You need to ensure
that the “Node Status” is “online”, as shown above. If it is not, again, shout
for help!
Scroll back to the top, and under the
“Index administration” section, ensure the indexes are enabled.
Figure 37: Index Administration with Core Indexes Enabled
By default, the “All work” is not ticked.
This does not really matter.
Click the Check button one-by-one, make
sure you have a message indication that all are well as shown below:
Figure 38: Diagnostic Messages of the Search Indexes
If you are curious, you can always try to
click the “Re-index” button, and you should see this:
Figure 39:Re-Indexing Dialog Box
Just go ahead and select “All Classes”.
Figure 40: Re-Indexing Confirmation Window
Observe the index, it should be progressing
as shown below:
Figure 41: Re-Indexing in Progress
Once everything is done, you will be back
to the screen, showing the completed index sizes.
Of course, Murphy’s Law applies, if it is
not broken, don’t fix it, unless you have a lot of time to play around with it.
No comments:
Post a Comment